RTC clock synchronization buffer driver delay chip
HGSEMI (Huaguan)
Pengeluar
RENESAS (Renesas)/IDT
Pengeluar
I2C interface (RTC), working voltage: 2.7V-5.5V
Penerangan
TI (Texas Instruments)
Pengeluar
onsemi (Ansemi)
Pengeluar
TI (Texas Instruments)
Pengeluar
CMOS Programmable Timer 16-PDIP -55 to 125
Penerangan
ST (STMicroelectronics)
Pengeluar
ADI (Adeno)/MAXIM (Maxim)
Pengeluar
I2C, 2-wire serial port
Penerangan
RENESAS (Renesas)/IDT
Pengeluar
HTCSEMI (Haitian core)
Pengeluar
onsemi (Ansemi)
Pengeluar
The NB100LVEP221 is a low-skew 2:1:20 differential driver for clock distribution, accepting two clock sources into one input multiplexer. The two clock inputs are differential ECL/PECL; CLK1/CLK1bar can also accept HSTL signal levels. The LVPECL input signal can be differential or single-ended (if using the VBB output). The LVEP221 specifically guarantees low output-to-output skew. Excellent design, layout, and handling techniques minimize skew within the device and from device to device. To ensure the tightest skew, both sides of the differential output are equally terminated to 50Ω, even if only one side is used. If an output pair is not used, both outputs can be left open (unterminated) without affecting the skew ratio. Like most other ECL devices, the NB100LVEP221 can be powered from a positive VCC supply in LVPECL mode. Therefore, using the LVEP221 in +3.3 V or +2.5 V systems enables high performance clock distribution. In a PECL environment, serial or Thevenin line terminations are often used because they do not require an additional power supply. Designers should refer to application note AND8020/D for more information on using PECL termination. Only the VBB pin, the internally generated supply voltage, is provided for this device. In the case of single-ended LVPECL inputs, tie the unused differential input to VBB as the switch reference voltage. VBB can also re-bias the AC-coupled input. When used, decouple VBB and VCC through a 0.01 uF capacitor and limit current to source or sink 0.5 mA. VBB should be left open when not in use. Single-ended CLK input operation is limited to VCC >= 3.0 V in LVPECL mode and VEE <= -3.0 V in NECL mode.
Penerangan
TI (Texas Instruments)
Pengeluar
DIODES (US and Taiwan)
Pengeluar
ADI (Adeno)/MAXIM (Maxim)
Pengeluar
TI (Texas Instruments)
Pengeluar
CDCM9102 Low Noise Dual Channel 100MHz PCIe Clock Generator
Penerangan
HGC (Shenzhen Hanxin)
Pengeluar
HTCSEMI (Haitian core)
Pengeluar
Micro-power real-time clock with 56 Х 8 RAM serial interface, supports oscillator operation in battery mode
Penerangan
Micro Crystal (Swiss Micro Crystal)
Pengeluar
MICROCHIP (US Microchip)
Pengeluar
ADI (Adeno)/MAXIM (Maxim)
Pengeluar